UniModSet / MetcomTSet - baer-gmbh.com

More documents

Recommendations

Info

UniModSet / MetcomTSet 32 Additionally functions: It is possible to unlock the SIM card with PIN or to change the PIN: As well as to check the signal quality of a connected UniMod GSM-4: The top indicator shows the average field strength, the one below shows the field strength at the moment. Additionally you can see the temperature at the board near the CPU.
UniModSet / MetcomTSet Optionally the field strength at the place of the remote modem can be checked. This will need a special version of the device which can be ordered at the manufacturer. � The password for local and remote modem must be differently (if you use two UniMod...). In order to fulfill that request, the parameters of the local modem (baud rate and data format) have to be set correctly first in the menu "Remote Modem". After that, you have to enter the telephone number and the correct (!) password for the remote modem. Click on the button “Connect”: link to the remote modem (wait for 1 minute max., depending upon the network connection). With the “Read” check box, communication to the remote modem will be enabled. If the check box “Info” is selected, additional information from the remote device will be read (e.g. Firmware version). This feature increases the readout time slightly. The check box “GPRS (Timeout)” enables adjusting the timeout for the GPRS communication (up to 20 sec.). Note: For data format = 8N1 (needed for firmware update) is possible to set the check box “Remote 7E” for correct reading the settings from the remote UniMod GSM- 4 (with data format 7E1): 33
Page 1 and 2: UniModSet / MetcomTSet Parameteriza
Page 3 and 4: Table of Contents UniModSet / Metco
Page 5 and 6: 3 Installation For installation run
Page 7 and 8: Examples: 4.1 UniMod... with parame
Page 9 and 10: 5 Settings The global system settin
Page 11 and 12: 6 Configuration UniModSet / MetcomT
Page 13 and 14: UniModSet / MetcomTSet It is possib
Page 15 and 16: UniModSet / MetcomTSet It is also p
Page 17 and 18: UniModSet / MetcomTSet Optionally t
Page 19 and 20: 6.3 GSM-3 for UniMod GSM-3 / GSM-3H
Page 21 and 22: UniModSet / MetcomTSet Optionally i
Page 23 and 24: The following registers exist for G
Page 25 and 26: 6.4 GSM-4 for UniMod GSM-4 UniModSe
Page 27 and 28: UniModSet / MetcomTSet Optionally i
Page 29 and 30: UniModSet / MetcomTSet Since the fi
Page 31: UniModSet / MetcomTSet � Timeout:
Page 35 and 36: UniModSet / MetcomTSet Option: Sinc
Page 37 and 38: Optional it is possible to set the
Page 39 and 40: 6.7 Ethernet for UniMod Ethernet un
Page 41 and 42: 7 Change the configuration UniModSe
Page 43 and 44: Possible settings: UniModSet / Metc
Page 45 and 46: 10.1 Programming with the terminal
Page 47 and 48: UniModSet / MetcomTSet Request Answ
Page 49 and 50: 11 Protocol Test UniModSet / Metcom

UniModSet / MetcomTSet - baer-gmbh.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?