UniModSet / MetcomTSet - baer-gmbh.com

UniModSet / MetcomTSet
Option: Since firmware version #90 is possible to do a “Firmware Update” via local interface
(e.g. service RS232) or via mobile (GSM/PSTN modem or GPRS) connection.
Local: When doing a firmware update via RS232 service interface it is advisable to
remove or disable the SIM card in the modem.
Mobile: When doing a firmware update remotely via GSM/PSTN/GPRS connection the
data format must be set to 8N1 (set option “Read”, see picture below). If the
remote modem is set to 7E1 then the option “Remote 7E1” must be enabled also:
After clicking button “Firmware Update” the current parameter setting is read
from remote modem. Then the file containing the desired firmware can be selected
(e.g. from hard disk). The program checks now if the firmware of the remote
device can be updated. If yes, this message will appear:
A click on button “OK” starts the update. On success the following message appears:
After that the modem will perform a reset and boot the uploaded firmware.
Timeout: Local := 3 seconds; CSD := 30 seconds; GPRS := 3 minutes;
35