1.2 Structure of the Planning and installation guide - Shop

4 Installing the HDG Navora – Installing the HDG Navora 20/25/30 with HDG Lambda Control 1
3. Route the set of cables (1) through the opening in the lateral
brace (2) and plug them into the corresponding sockets on the
circuit board (3).
Figure 4/17 - Installing the HDG Lambda Control 1 controller
4. Connect the HDG Lambda Control 1 controller (1) with the
matching cables in the cable set (2). Using a Phillips-head
screwdriver, fasten the controller to the lateral brace (3) with the
enclosed sheet metal screws.
Figure 4/18 - Installing the HDG Lambda Control 1 controller
© HDG Bavaria GmbH 06/2008 HDG Navora 20/25/30 with HDG Lambda Control 1 - V 2 - en
2
1
2
2
1
3
51