11.01.2013 Views

The Multi Interface Controller (M.I.C.) is an on-line ... - VVV System sro

The Multi Interface Controller (M.I.C.) is an on-line ... - VVV System sro

The Multi Interface Controller (M.I.C.) is an on-line ... - VVV System sro

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

When you install Base Stati<strong>on</strong> for the first time, all of its parameters<br />

are bset in the default positi<strong>on</strong>. If th<str<strong>on</strong>g>is</str<strong>on</strong>g> c<strong>on</strong>figurati<strong>on</strong> doesn't corresp<strong>on</strong>d<br />

with your applicati<strong>on</strong>, you must c<strong>on</strong>figurate it.<br />

<str<strong>on</strong>g>The</str<strong>on</strong>g>re are two main ways to c<strong>on</strong>figure a Base Stati<strong>on</strong> unit:<br />

I) Via the RS232 port of a IBM PC-AT, with the special Windows<br />

based program.<br />

Th<str<strong>on</strong>g>is</str<strong>on</strong>g> user friendly software allows to updownload c<strong>on</strong>figurati<strong>on</strong>s to<br />

a large amount of Base Stati<strong>on</strong>s in a short time.<br />

No reader <str<strong>on</strong>g>is</str<strong>on</strong>g> required, just th<str<strong>on</strong>g>is</str<strong>on</strong>g> software <str<strong>on</strong>g>an</str<strong>on</strong>g>d a RS232 cable<br />

(M-01 DB25/DB9)<br />

Th<str<strong>on</strong>g>is</str<strong>on</strong>g> ONLY applies to RS232 hardware c<strong>on</strong>figured Base Stati<strong>on</strong>s<br />

II) Via a BARCODE menu. <str<strong>on</strong>g>The</str<strong>on</strong>g> user must read bar codes to c<strong>on</strong>figure<br />

the Base Stati<strong>on</strong>. A bar code reader <str<strong>on</strong>g>is</str<strong>on</strong>g> required with <strong>on</strong>e of the<br />

following interfaces: Laser, RS232 or Light pen emulati<strong>on</strong>.<br />

Once adjusted, the new parameters are saved in <str<strong>on</strong>g>an</str<strong>on</strong>g> Eprom (n<strong>on</strong><br />

volatile memory) which keeps the parameters values even if power-off.<br />

MS9530 Voyager RF Base Stati<strong>on</strong> - 13 - Printed: September 2002<br />

Versi<strong>on</strong>: 1.1 Status: Approved

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!