Turret Lathes - Hardinge Inc.

Special Collet Or der Form
Today’s Date: ___________________________ Please Specify Method of Shipping
Date Order Required: _____________________ _______________________________________
Customer Number: _______________________
Purchase Order Number: __________________
Is This Your First Order: Yes ❑ No ❑
Bill To: Ship To: (If different from Bill To)
Name: ______________________________ Name: _______________________________
Title/Dept.: ___________________________ Title/Dept.: ___________________________
Company: ___________________________ Company: ____________________________
Address: ____________________________ Address: _____________________________
City, State, Zip: _______________________ City, State, Zip: ________________________
Phone: ___________ Fax: ____________ Phone: ___________ Fax: _____________
• Fill in the Type of Collet being used, ex: Hardinge 16C. • Find the illustration of the configuration needed. • Put a Bold “X” in the
small box to indicate that configuration. • Write the required dimensions next to their corresponding numbers in the chart below.
Note: Only fill in the dimensions for the numbers from one illustration.
Type of Collet: (5C, Index B60, etc.)
1. Order Hole Size: _______________
2. Order Hole, 2nd: _______________
3. Number of Slots: _______________
4. Radius: ______________________
5. Bearing Length: ________________
6. Bearing Length Front: ___________
7. Back Drill Dia.: ________________
8. Relief Dia.: ___________________
9. Relief Length: _________________
10. Depth of Step, 1st: _____________
11. Depth of Step, 2nd.: ____________
12. Auxiliary Hole Size: ____________
13. Length of Extension: ___________
14. Dia. at Face: __________________
15. Degrees Taper/Chamfer: ________
16. Front Dim. of Taper: ____________
17. Rear Dim. of Taper: ____________
18. Taper-Industrial Std: ____________
19. Off Center Distance: ____________
20. Order Hole - Width: ____________
21. Order Hole - Length: ___________
22. Thread Length: ________________
23. Threads Per Inch:______________
24. Right/Left Hand Thrd.: __________
25. Class Thread (1), (2), (3): ________
26. Chamfer Depth: _______________
27. Inscribed Circle: _______________
28. Circumscribed Circle: ___________
29. Clearance Bore: _______________
30. Actuator Stroke: _______________
Bearing Relief Single Stepped Double Stepped
Chamfer - Depth Chamfer - Diameter Radius
Chapter 5
Page 143
Special Bearing Length Eccentric Step - Aux. Off Center Eccentric Step - Aux. On Center