IP Based 'Trunk-side' - CommPartners Connect

More documents

Recommendations

Info

Additional dial plan parameters can be modified to allow or deny certain call types for station users: The admin can also setup dial plan templates to allow/deny call types for different groups if needed:
Be sure to create the codec order so that “G.729” is the primary voice codec while “G.711” is selected at the fallback codec for faxing (T.38 Fo<strong>IP</strong> to be support in Q1 2006): The admin shouldn’t require any changes in this section but verification of the “FlashHook” parameters is recommended as seen below:
Page 1 and 2: SIP DS0 Service IP Based ‘Trunk-s
Page 3 and 4: II. Configuration Wizard Setup thro
Page 5 and 6: The first prompt will ask the user
Page 7 and 8: Configuration parameters for the SI
Page 9 and 10: The “IP Services” section will
Page 11: If the configuration wizard was use
Page 15 and 16: Enable “IP Routing” when utiliz
Page 17 and 18: FXS PROVISIONING: interface fxs 0/1
Page 19 and 20: interface t1 0/2 framing esf coding
Page 21 and 22: did digits-transferred 4 (Number of
Page 23 and 24: Analog User - Station Configuration
Page 25: Show media-gateway Channel Info Ses

IP Based 'Trunk-side' - CommPartners Connect

Create successful ePaper yourself

Delete template?

Save as template?