IP Based 'Trunk-side' - CommPartners Connect

More documents

Recommendations

Info

I. Installation of the Adtran TA912/924 VoIP Gateway Site Requirements: (1) Adtran TA912/924 VoIP gateway (1) Adtran TA912/924 Software/Firmware Version 10.02.00 (1) Open PRI-ISDN Interface on existing legacy PBX switch (1) 10/100 Ethernet port to Broadband Router or T1 WAN Circuit (1) 1RU of free space on existing 19”network rack installation (1) 120V-AC Power Connection Front View: Rear View:
II. Configuration Wizard Setup through HTTP Interface Once the user has logged into the TA912/924 through the serial interface, the TA can be easily setup through the HTTP server interface which will allow the user to simply fill in the required configuration fields with the “point-and-click” interface. First the user will need to enable the HTTP service and setup the IP address of the Ethernet port: AOS Configuration (CLI) User Access Login Password: TA912>conf t TA912>en Password: TA912#conf t TA912(config)#ip http server TA912(config)#login TA912(config)#username admin password adtran TA912(config)# TA912(config)#interface ethernet 0/1 TA912(config-eth 0/1)# ip address 24.120.226.51 255.255.255.128 TA912(config-eth 0/1)# media-gateway ip primary TA912(config-eth 0/1)#no shut TA912(config-eth 0/1)#CTRL+Z TA912(config)# ip route 0.0.0.0 0.0.0.0 24.120.226.1 TA912(config)#copy run star Building configuration... Done. Success! TA912# IAD MANAGEMENT: enable SET THE TIME CLOCK: clock set 16:40:00 3 june 2005 clock timezone –8 NAME THE IAD: conf t hostname “TA912” PASSWORD PROTECT THE ENABLE MODE: enable password adtran PASSWORD PROTECT TELNET ACCESS: line telnet 0 login password adtran PUT AN IP ADDRESS ON THE ETHERNET PORT: interface e 0/1 ip address x.x.x.x 255.255.255.0 no shutdown
Page 1: SIP DS0 Service IP Based ‘Trunk-s
Page 5 and 6: The first prompt will ask the user
Page 7 and 8: Configuration parameters for the SI
Page 9 and 10: The “IP Services” section will
Page 11 and 12: If the configuration wizard was use
Page 13 and 14: Be sure to create the codec order s
Page 15 and 16: Enable “IP Routing” when utiliz
Page 17 and 18: FXS PROVISIONING: interface fxs 0/1
Page 19 and 20: interface t1 0/2 framing esf coding
Page 21 and 22: did digits-transferred 4 (Number of
Page 23 and 24: Analog User - Station Configuration
Page 25: Show media-gateway Channel Info Ses

IP Based 'Trunk-side' - CommPartners Connect

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?