IP Based 'Trunk-side' - CommPartners Connect

More documents

Recommendations

Info

If the T1 WAN access is to be used, then specify whether a DHCP served address will be used. If a static IP address is going to be used, then proceed to fill in the IP address and Subnet Mask information. Confirm that the VoIP Parameters are set to the default values as shown below:
Configuration parameters for the SIP trunk with the Commpartners network are included below: Begin the configuration for each individual FXS analog port as seen below:
Page 1 and 2: SIP DS0 Service IP Based ‘Trunk-s
Page 3 and 4: II. Configuration Wizard Setup thro
Page 5: The first prompt will ask the user
Page 9 and 10: The “IP Services” section will
Page 11 and 12: If the configuration wizard was use
Page 13 and 14: Be sure to create the codec order s
Page 15 and 16: Enable “IP Routing” when utiliz
Page 17 and 18: FXS PROVISIONING: interface fxs 0/1
Page 19 and 20: interface t1 0/2 framing esf coding
Page 21 and 22: did digits-transferred 4 (Number of
Page 23 and 24: Analog User - Station Configuration
Page 25: Show media-gateway Channel Info Ses

IP Based 'Trunk-side' - CommPartners Connect

Create successful ePaper yourself

Delete template?

Save as template?