IP Based 'Trunk-side' - CommPartners Connect

More documents

Recommendations

Info

Verify that all of the configuration settings are correct and proceed to click on the “finish” tab to confirm: If the admin would like to configure additional parameters then proceed to click on the “System” tab: The “Passwords” section will allow the administrator to assign additional user accounts and passwords:
The “<strong>IP</strong> Services” section will allow the admin to open or close the HTTP server ports as seen below: The admin can also allow for a DHCP host server for LAN clients as well:
Page 1 and 2: SIP DS0 Service IP Based ‘Trunk-s
Page 3 and 4: II. Configuration Wizard Setup thro
Page 5 and 6: The first prompt will ask the user
Page 7: Configuration parameters for the SI
Page 11 and 12: If the configuration wizard was use
Page 13 and 14: Be sure to create the codec order s
Page 15 and 16: Enable “IP Routing” when utiliz
Page 17 and 18: FXS PROVISIONING: interface fxs 0/1
Page 19 and 20: interface t1 0/2 framing esf coding
Page 21 and 22: did digits-transferred 4 (Number of
Page 23 and 24: Analog User - Station Configuration
Page 25: Show media-gateway Channel Info Ses

IP Based 'Trunk-side' - CommPartners Connect

Create successful ePaper yourself

Delete template?

Save as template?