IP Based 'Trunk-side' - CommPartners Connect

More documents

Recommendations

Info

Verify that the “SIP Registrar” services are enabled as seen below: Setup the “Default Gateway” if required when using an external broadband router for the WAN:
Enable “IP Routing” when utilizing an external broadband router for the WAN: Configuration of the IP Address for the Ethernet port is required if the admin has not configured the port already in the configuration wizard: The system configuration can be saved to an external configuration file and the admin will have the ability to restore the configuration if needed:
Page 1 and 2: SIP DS0 Service IP Based ‘Trunk-s
Page 3 and 4: II. Configuration Wizard Setup thro
Page 5 and 6: The first prompt will ask the user
Page 7 and 8: Configuration parameters for the SI
Page 9 and 10: The “IP Services” section will
Page 11 and 12: If the configuration wizard was use
Page 13: Be sure to create the codec order s
Page 17 and 18: FXS PROVISIONING: interface fxs 0/1
Page 19 and 20: interface t1 0/2 framing esf coding
Page 21 and 22: did digits-transferred 4 (Number of
Page 23 and 24: Analog User - Station Configuration
Page 25: Show media-gateway Channel Info Ses

IP Based 'Trunk-side' - CommPartners Connect

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?