Chapter 3 - Rolling of metals

More documents

Recommendations

Info

Shaped rolling or section rolling • A special type of cold rolling in which flat slap is progressively bent into complex shapes by passing it through a series of driven rolls. • No appreciable change in the thickness of the metal during this process. • Suitable for producing moulded sections such as irregular shaped channels and trim. Suranaree University of Technology Tapany Udomphol Jan-Mar 2007
Shaped rolling or section rolling A variety of sections can be produced by roll forming process using a series of forming rollers in a continuous method to roll the metal sheet to a specific shape A variety of rolled sections www.formtak.com Applications: - construction materials, - partition beam - ceiling panel - roofing panels. - steel pipe - automotive parts - household appliances - metal furniture, - door and window frames - other metal products. Suranaree University of Technology Tapany Udomphol Jan-Mar 2007
Page 1 and 2: Rolling of metals Subjects of inter
Page 3 and 4: www.world-aluminium.org Introductio
Page 5 and 6: Sheet rolling machines Rolled strip
Page 7 and 8: Rolls Mill rolls Mill rolls Suranar
Page 9 and 10: Typical arrangement of rollers for
Page 11 and 12: Typical arrangement of rollers for
Page 13 and 14: Different types of rolling processe
Page 15: Transverse rolling • Using circul
Page 19 and 20: Simulation of ring rolling Simulati
Page 21 and 22: Powder rolling Metal powder is intr
Page 23 and 24: Thread rolling Cut thread and rolle
Page 25 and 26: Example for hot strip mill process
Page 27 and 28: Cold-rolling Cold rolling www.willi
Page 29 and 30: Cold-rolling Cold rolling • Cold
Page 31 and 32: h o Forces and geometrical relation
Page 33 and 34: • At only one point along the sur
Page 35 and 36: h o v o p A R N B h f Friction hill
Page 37 and 38: Therefore Free engagement will occu
Page 39 and 40: Problem with roll flattening When h
Page 41 and 42: Simplified analysis of rolling load
Page 43 and 44: 2) Normal friction situation In the
Page 45 and 46: • Frictional force is needed to p
Page 47 and 48: 3) Sticky friction situation What w
Page 49 and 50: Relationship of µµµµ, rolling l
Page 51 and 52: Problems and defects in rolled prod
Page 53 and 54: Uniform thickness • Under high ro
Page 55 and 56: Flatness • The roll gap must be p
Page 57 and 58: • Hot mill can be provided with f
Page 59 and 60: Possible effects when rolls are ove
Page 61 and 62: • Edging can also be caused by in
Page 63 and 64: Rolling mill control • Modern con
Page 65 and 66: Rolling load P3 P2 P1 Situation whe
Page 67 and 68:
Thickness measurement in continuous
Page 69 and 70:
The stresses acting on an element o
Page 71 and 72:
The forces acting in the vertical d
Page 73 and 74:
The rolling load or total force P i
Page 75 and 76:
Torque and power Torque is the meas
Page 77 and 78:
The torque M T is equal to the tota
Page 79:
References • Dieter, G.E., Mechan
show all

Chapter 3 - Rolling of metals

Create successful ePaper yourself

Delete template?

Save as template?