Robotic and Manual Pan & Tilt Head - Vinten Radamec

More documents

Recommendations

Info

f Figure 7 Set pan, tilt & height limits dialog box (f) Pan maximum and minimum limits (g) Tilt maximum and minimum limits 12. Enter the angle of travel (in degrees) either side of the zero datum position for both pan and tilt axes. The positive direction of travel on the pan axis is in a clockwise direction when the Head is viewed from above, and the positive direction of travel for the tilt axis is in a clockwise direction when viewed from the left-hand side of the camera cradle as shown in Figure 8. Positive angle of travel on the tilt axis. Positive angle of travel on the pan axis. Figure 8 Angles of travel on the pan and tilt axes 13. When done, click Apply and then OK to close the dialog box. 14. Click OK to close the Vinten Fusion Robot Control window (Figure 6). 15. Switch OFF the power to the Head. 16. Disconnect the lead from the USB port and reconnect the EPL cable. 17. Switch ON the power to the Head. g Negative angle of travel on the tilt axis. Negative angle of travel on the pan axis. 11
From the Control Panel, carefully drive the Head to its limits in both pan and tilt axes using the joystick to determine if the limits have been correctly set. 12 ! Warning! Closely observe the camera movement while checking the software axis limits to avoid potential personal injury or damage to the equipment.
Page 1 and 2: Robotic Camera Control Systems Vint
Page 3 and 4: Copyright © Vitec Group plc 2009 A
Page 5 and 6: List of Figures Figure 1 Standard A
Page 7 and 8: Disposing of old electronic equipme
Page 9 and 10: Safety when working with Robotic eq
Page 11 and 12: Features and Controls Camera cradle
Page 13 and 14: Four-hole mounting plate with Quick
Page 15 and 16: Mounting the head The Head has a st
Page 17 and 18: Fitting a vanity mirror A vanity mo
Page 19 and 20: There are two EPL ports on the Pede
Page 21 and 22: Setting fore and aft balance When p
Page 23: 11. Click SET PAN,TILT, X/Y AND HEI
Page 27 and 28: Operating the Head in Robotic mode
Page 29 and 30: Operating the Head in Manual mode T
Page 31 and 32: Maintenance Routine checks During u
Page 33 and 34: Troubleshooting 20 Fault Check Read
Page 36 and 37: Index abrasives 17 accessories, Opt
Page 38: CHINA The Vitec Group plc China Rm

Robotic and Manual Pan & Tilt Head - Vinten Radamec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?