Installation & Service Manual - Rex Materials Group
Installation & Service Manual - Rex Materials Group
Installation & Service Manual - Rex Materials Group
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Teflon Zone Cover <strong>Installation</strong><br />
Teflon Zone Covers are used to cover small gaps between Heaters and to protect the Heater’s<br />
outside surfaces from contamination. Cover installation steps are as follows:<br />
1. Wrap Teflon Zone Covers around Heaters and tuck in excess tail under the lead edge of the<br />
cover. See Figure 2-3 & 2-4.<br />
2. Trim or cut holes in Zone Covers for thermocouple adapters (and sensors). See Figure 2-3 & 2-<br />
4.<br />
3. Run Lead Wires under Zone Covers and out Zone Cover ends. See Figure 2-3 & 2-4.<br />
2<br />
TRIM COVERS AROUND<br />
THERMOCOUPLE ADAPTERS<br />
ZONE 3 ZONE 2<br />
RUN LEAD WIRES UNDER ZONE COVERS<br />
AND OUT ZONE COVER ENDS 3<br />
1<br />
FIGURE 2-3<br />
Teflon Zone Cover <strong>Installation</strong> View<br />
24<br />
WRAP TEFLON ZONE COVERS AROUND HEATERS<br />
AND TUCK IN EXCESS TAIL<br />
ZONE 1