Installation & Service Manual - Rex Materials Group

Recommendations

Info

Teflon Zone Cover Installation Teflon Zone Covers are used to cover small gaps between Heaters and to protect the Heater’s outside surfaces from contamination. Cover installation steps are as follows: 1. Wrap Teflon Zone Covers around Heaters and tuck in excess tail under the lead edge of the cover. See Figure 2-3 & 2-4. 2. Trim or cut holes in Zone Covers for thermocouple adapters (and sensors). See Figure 2-3 & 2- 4. 3. Run Lead Wires under Zone Covers and out Zone Cover ends. See Figure 2-3 & 2-4. 2 TRIM COVERS AROUND THERMOCOUPLE ADAPTERS ZONE 3 ZONE 2 RUN LEAD WIRES UNDER ZONE COVERS AND OUT ZONE COVER ENDS 3 1 FIGURE 2-3 Teflon Zone Cover Installation View 24 WRAP TEFLON ZONE COVERS AROUND HEATERS AND TUCK IN EXCESS TAIL ZONE 1
Cut the Teflon cover flap as needed to allow for wires and thermocouple adaptors. Install Teflon cover with flap over the terminals, and fasten with silicone O-rings. Wires can be neatly routed underneath the flap in the Teflon cover or captured outside the flap by O-rings. FIGURE 2-4 This completes the installation of your Rex TCS Heater System. 25
Page 1 and 2: Thermal Control Solution Installati
Page 3 and 4: Introduction Section One Introducti
Page 5 and 6: About This Guide This manual will 1
Page 7 and 8: Equipment Overview Rex TCS Systems
Page 9 and 10: Installation & Assembly Section Two
Page 11 and 12: tuning controllers is recommended t
Page 13 and 14: Removing Packaging and Handling You
Page 15 and 16: Rex TCS Heater Assembly Installatio
Page 17 and 18: 5. 17 No terminals on the back side
Page 19 and 20: 9. B Measure dimension B from edge
Page 21 and 22: SINGLE ZONE 2 HALF HEATERS IN SERIE
Page 23: CERAMIC CAP CERAMIC COVER NUT LOCK
Page 27 and 28: Operation Overview Before applying
Page 29 and 30: Documenting Savings and Performance
Page 31 and 32: Barrel Overheating If the zone temp
Page 33: How to Order Spare Parts The Rex TC

Installation & Service Manual - Rex Materials Group

Create successful ePaper yourself

Delete template?

Save as template?