Installation & Service Manual - Rex Materials Group

Recommendations

Info

Appendix Section Four How to Order Spare Parts 33 32
How to Order Spare Parts The Rex TCS Heaters and End Rings if used are custom made to fit the specific machine requirements and are not normally stocked by Rex Materials. It is strongly recommended that the Customer stock at least one heater half for each different heater assembly on the machine. Spare parts should be ordered from the authorized TCS distributor where you purchased the original TCS system. You can also contact Rex Materials Customer Service Department for assistance in identifying correct spare parts. Telephone: 1-517-223-3787 Fax: 1-517-223-6806 E-Mail: customerservice@rexmaterials.com When ordering spare parts, include the TCS-xxxxxxx part number, the description as shown on the Heater or Installation Bill of Material. 33
Page 1 and 2: Thermal Control Solution Installati
Page 3 and 4: Introduction Section One Introducti
Page 5 and 6: About This Guide This manual will 1
Page 7 and 8: Equipment Overview Rex TCS Systems
Page 9 and 10: Installation & Assembly Section Two
Page 11 and 12: tuning controllers is recommended t
Page 13 and 14: Removing Packaging and Handling You
Page 15 and 16: Rex TCS Heater Assembly Installatio
Page 17 and 18: 5. 17 No terminals on the back side
Page 19 and 20: 9. B Measure dimension B from edge
Page 21 and 22: SINGLE ZONE 2 HALF HEATERS IN SERIE
Page 23 and 24: CERAMIC CAP CERAMIC COVER NUT LOCK
Page 25 and 26: Cut the Teflon cover flap as needed
Page 27 and 28: Operation Overview Before applying
Page 29 and 30: Documenting Savings and Performance
Page 31: Barrel Overheating If the zone temp

Installation & Service Manual - Rex Materials Group

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?