3130/3130xl Genetic Analyzers Getting Started Guide, Rev - Applied ...
3130/3130xl Genetic Analyzers Getting Started Guide, Rev - Applied ...
3130/3130xl Genetic Analyzers Getting Started Guide, Rev - Applied ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Notes<br />
Chapter 2 Performing a Spatial Calibration<br />
Spatial Calibration<br />
Spatial Calibration<br />
When to Perform<br />
the Calibration<br />
The <strong>3130</strong>/<strong>3130</strong>xl genetic analyzer Data Collection software uses images collected during<br />
the spatial calibration to establish a relationship between the signal emitted by each<br />
capillary and the position where that signal falls on and is detected by the CCD camera.<br />
You are required to perform a spatial calibration when you:<br />
Install or replace a capillary array<br />
Temporarily remove the capillary array from the detection block<br />
Move the instrument<br />
Creating a Spatial Calibration File<br />
Positions (pixel)<br />
of each capillary<br />
1. In the tree pane of the Data Collection software, click<br />
GA Instruments > ga<strong>3130</strong> or ga<strong>3130</strong>xl > instrument<br />
name > Spatial Run Scheduler.<br />
Spatial<br />
profile<br />
Start, Accept<br />
or Reject<br />
Spatial profile<br />
22 <strong>Applied</strong> Biosystems <strong>3130</strong>/<strong>3130</strong>xl <strong>Genetic</strong> <strong>Analyzers</strong> <strong>Getting</strong> <strong>Started</strong> <strong>Guide</strong><br />
DRAFT<br />
November 3, 2004 9:51 am, 02_SpatialCal.fm
Change language