250/300/380 sx,mxc,exc repair manual engine - Tanga Moteurs

5-17C
LOCTITE 243
3
LOCTITE 243
5
A
2
7
8
Kickstarter
Starter gear 1
Check clearance of starter gear.
Starter intermediate gear 2
Check clearance of starter intermediate gear.
Locking pawl 3
Check for signs of wear and damage.
Kickstarter shaft 4
Check for signs of wear and damage.
1
6
LOCTITE 648
For changing the locking pawl, press bearing needle 9 out of the
kickstarter shaft.
Assemble of kickstarter shaft
– Fix the kickstarter shaft 4 in a vice with the toothed end upwards (use
covered vice clamps).
– Mount ratchet spring 5 on kickstarter shaft as shown in the
illustration.
– Place needle cage 6 in position, push starter gear 1 over it, pressing
locking pawl 3 inwards so that starter gear passes smoothly over it.
– Hook legs of the starter spring 7 into driving hub 8, push both
together on the starter shaft, hook starter spring leg into kickstarter
shaft bore A.
– Release kickstarter shaft, and fix stop disc bk with a small amount of
grease on the kickstarter shaft.
4
9
3
5
10