Backyard Circus Club
Backyard Circus Club
Backyard Circus Club
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Step 2<br />
1 1/4"<br />
H1<br />
H108<br />
650<br />
HOLE<br />
DOWN<br />
INSET A<br />
638<br />
639<br />
58"<br />
HOLE UP<br />
DETAIL A<br />
H108 647<br />
H1<br />
H108<br />
H108<br />
H1<br />
H1<br />
HOLE DOWN<br />
Wall Assembly<br />
*NOTE: Pre-drill holes for all 5/16" Lag Bolts with a 1/8" drill bit.<br />
*SUGGESTION: Two or three people may be required to complete this step.<br />
1. Stand both wall assemblies up and attach with 4 Hole Facias (418) using 1/4" Hardware (H1) and<br />
5/16" Hardware (H108). Ensure assembly is square. Assembly should measure<br />
52" wide when properly assembled.<br />
*NOTE: 4 Hole Facias (418) must be flush with bottoms of Corner Uprights (638) (639).<br />
Holes are offset, orient as shown in Inset A.<br />
*SUGGESTION: When installing Facias, put bottom lag bolts in first and check that<br />
measurements are correct and assembly is square before inserting top lag bolts.<br />
2. Measure up 58" on Uprights and attach 6 Hole Facia (715), with inside holes down, and 4 Hole<br />
Facias (650) using 1/4" Hardware (H1) and 5/16" Hardware (H108).<br />
*NOTE: Facias (645) (647) (650) (715) must be positioned so holes are offset.<br />
3. Attach 6 Hole Facias (647) to Uprights using 1/4" Hardware (H1) and 5/16" Hardware (H108).<br />
Top faces should be flush with tops of Top Joist (643) and Facia w/Rope Hole (645).<br />
715<br />
418<br />
21<br />
645<br />
418<br />
A<br />
715<br />
418<br />
638<br />
639<br />
643<br />
52"<br />
647<br />
H1<br />
H108