Fiesta Playhouse Hardware List

Step 1
H108 H1
H108
553
H108
H1
H1
224
554
231
44"
553
553
589
224
INSET A
44"
553
24"
Wall Assembly
*NOTE: Pre-drill holes for all 5/16" Lag Bolts with a 1/8" drill bit.
1. Position Corner Uprights (553) (554) on the ground and insert 3/8" Hardware (H30) into pre-drilled
holes (as shown in INSET A).
2. On a flat surface, position Corner Uprights (553) (554) (as shown) with 3/8" Hardware (H30)
facing in.
*NOTE: Holes on 4 Hole Facias (231) are offset. See Detail B for proper installation.
3. Place 4 Hole Facias (231) flush with the bottoms of Corner Uprights (553) (554), square and
attach 4 Hole Facias (231) using 1/4" Hardware (H1) and 5/16" Hardware (H108).
4. Position 2 Hole Facias (224) 1/2" down on Corner Uprights (553) and 50" up on Corner Uprights
(554) and attach using 1/4" Hardware (H1) and 5/16" Hardware (H108).
*NOTE: Make sure each wall assembly is square at this time.
5. Position two 2 Hole Facias (224) directly on top of 4 Hole Facias (231) (as shown) and attach
to Corner Uprights (553) using 1/4" Hardware (H1) and 5/16" Hardware (H108).
6. Position 2 Hole Facias (224) 22" up on Corner Uprights (554) and 24" up on Corner Uprights
(553) (as shown) and attach using 1/4" Hardware (H1) and 5/16" Hardware (H108).
7. Position Arched Facias (589) (590) 44" up on Corner Uprights (553) and attach using 1/4"
Hardware (H1) and 5/16" Hardware (H108).
8. Position Arched Facia (589) up against the bottom of 2 Hole Facia (224) and attach to Corner
Uprights (554) using 1/4" Hardware (H1) and 5/16" Hardware (H108).
224
231
45"
15
224
590
553
224
H30
1/2"
1 3/4"
THIS HOLE UP
224
B
589
224
554
231
H30
DETAIL B
DETAIL A
H1
22"
50"
H108