Fiesta Playhouse Hardware List

Step 7
H152
580
567
EDGE CLOSEST
TO HOLE MUST
FACE IN
567
566
H194
H194
580
45"
579
566
H152
Roof Panel
Assembly
*SUGGESTION: Using a second person to stabilize or help hold supports while assembling
this step will ensure assembly remains square.
*SUGGESTION: Complete this step on a flat surface.
1. Position Left Roof Support (579) and Right Roof Support (580) 45" apart (from inside face to inside
face) on a flat surface.
2. Position Top/Bottom Roof Frames (567), with holes facing in, centered on top of Supports (579)
(580).
3. Top Roof Frame (567) should extend past the tip of Supports (579) (580) no more than a 1/4".
Position the Bottom Roof Frame (567) 32 1/8" from the Top Roof Frame (567). Attach Frames
(567) to Supports (579) (580) using #8 Hardware (H152).
*NOTE: Make sure assembly is square before completing part 4 of this step.
*SUGGESTION: Use Roof Frame Sides (566) to properly position (center) Roof Boards (524).
4. Position Roof Boards (524), centered and evenly spaced, on Supports (579) (580) and attach
using #8 Hardware (H194).
5. Place Roof Frame Sides (566) on the ends of Roof Boards (524) and attach using #8 Hardware
(H152).
6. Position Runner Board (576) (as shown) on the underside of Roof Boards (524) and attach using
#8 Hardware (H194) and to Top Roof Frame (567) using #8 Hardware (H152).
H152
1/4"
3"
524
COUNTER SUNK
HOLES FACE OUT
21
567
579
567
567
576
32 1/8"
INSET A
1"
567
INSET B
567
576
H152
576
H152
567