Progress Sonic 8.0 ESB Configuration and Management Guide

Chapter 1: Using Progress Sonic ESB Configuration and Management Tools
Basic Commands
Most of the commands act on a connected Directory Service store so connect is typically
the first command entered in an ESB Admin session.
connect
connect domain URL [username password] [managementNode]
Connect to the domain manager at the specified URL. For example:
connect Domain1 tcp://myHost:2506 anAdmin aPwd
where:
● Domain is the Directory Service store where administration will occur.
● URL is the IP address or DNS name resolvable to the broker and port of a management
broker of Domain in the form protocol://host:port. A URL list can be used when
delimited by commas and enclosed in quotes. For example:
connect Domain1 “tcp://myHost:2506,tcp://myHostBackup:2506” anAdmin aPwd
● username password are the administrator credentials for authentication on the broker.
● managementNode is the routing definition name on the non-management broker or
cluster that routes management communications to the management node. For more
information, see the “Management Over Dynamic Routing” in the “Multiple Nodes
and Dynamic Routing” chapter of the Progress SonicMQ Deployment Guide.
Note that the syntax of the connect command requires that, if you need to specify a
managementNode, username and password must be specified as well.
disconnect
disconnect
Disconnect from the domain manager.
exit
bye exit
The exit commands stop the tool and close its window.
help
help ?
The help commands list the available ESB Admin commands and their syntax.
36 Progress Sonic ESB Configuration and Management Guide 8.0