944-0140 D20MX Substation Gateway ... - GE Digital Energy

More documents

Recommendations

Info

D20MX upgrade kits Table 8 lists the available D20 MX upgrade kits. Table 8: D20MX upgrade kits Part Number Description Table 9 lists the parts provided in each D20MX upgrade kit. Table 9: Upgrade kit parts CHAPTER 1: BEFORE YOU START D20MX-N-SET-F-XX-X D20MX CPU, 2 x 10/100/1000 Base TX Front Access ports (RJ45) D20MX-N-SEF-F-XX-X D20MX CPU, 2 x 100 Base FX Front access ports (ST Connectors) D20MX-N-SEF-R-XX-X D20MX CPU, 2 x 100 Base FX Rear Access ports (ST Connectors) Part Number Part Description D20MX-N-SET-F-XX-X 526-3001 D20MX CPU non VME 2x10/100/1000 BaseTX 1 526-3003 D20MX CPU non VME 2x100 BaseFX (Front Access) 1 526-3005 D20MX CPU non VME 2x100 BaseFX (Rear Access) 1 526-3104 D20MX 100Base-FX Rear ST FO Card 1 975-1236 D20MX CPU to D20MX Rear FO Card Harness 1 975-1237 Termination panel to Backplane 0 V Harness 1 1 1 953-1014 Blank Plate for D20MX Install 1 1 1 953-1015 Lower filler cover plate 1 1 1 581-0002 GE Digital Energy Products Documentation CD 1 1 1 588-0075/00 GE Digital Energy D20MX Documentation CD 1 1 1 588-0077/00 GE Digital Energy SGConfig 7.0 Setup Software DVD 1 1 1 977-0529/72 Cable, Null Modem DB9F-DB9F, 80 °C, 150 V 1 1 1 460-0073 Ferrite clamp 1 1 1 24 GENERAL D20MX HARDWARE USER’S MANUAL D20MX-N-SEF-F-XX-X D20MX-N-SEF-R-XX-X
CHAPTER 1: BEFORE YOU START Product specifications System Communications Electrical The D20MX adheres to the following system, communications, electrical, physical and environmental specifications. Additional Standards and Protection are listed in Appendix A, Standards & Protection. Processor 667 MHz embedded PowerQUICC II Pro Memory 1024 MB of 266 MHz DDR2 RAM with ECC 16 MB NVRAM for persistent event storage Storage 8 MB boot flash 256 MB firmware flash Operating system VxWorks LED indicators System status: Power, Ready Ethernet port status: Link and Activity status per port Power supply: Power IRIG: Flashes when active. Network connections Dual redundant Ethernet interface Twisted Pair 10/100/1000BaseT (Isolated RJ-45 connector) 100BaseFX (Fiber Optic: 1300 nm, 50/125 µm, 62.5/125 µm multi-mode duplex fiber cable, ST connectors) Serial communications D.20 Link, 2 channels Data rate: 250 kbps Surge protected to ±2000 V peak RS-232, 7 channels 5-signal (TXD, RXD, RTS#, CTS#, DCD#) DTE ports Data rate: independently-selectable; refer to the application configuration guides. Maintenance Port RS-232, 1 channel/ 2 ports 2-signal (TXD, RXD) Data rate: 19200 (default) Rated power supplies AC-DC 100 to 240 V AC (±10%) 143 W output maximum Minimum/Maximum AC voltage: 90 V AC / 265 V AC 100 to 300 V DC (±10%) 143 W output maximum Minimum/Maximum DC voltage: 88 V DC / 330 V DC DC-DC 20 to 55 V DC (±10%) 135 W maximum Minimum/Maximum DC voltage: 18 V DC / 60 V DC Peak inrush current at AC-DC 50 A, max at 230 V AC 25 °C on cold start DC-DC 50 A, max at 230 V AC Rated frequency� (AC-DC) 50/60 Hz nominal (47 to 63 Hz) D20MX HARDWARE USER’S MANUAL GENERAL 25
Page 1 and 2: GE Digital Energy Hardware User’s
Page 3 and 4: ABOUT THIS DOCUMENT D20MX Processor
Page 5 and 6: TABLE OF CONTENTS SGConfig firmware
Page 7 and 8: D20MX Processor About this Document
Page 9 and 10: ABOUT THIS DOCUMENT Safety words an
Page 11 and 12: D20MX Processor Product Support Pro
Page 13 and 14: D20MX Processor Chapter 1: Before Y
Page 15 and 16: CHAPTER 1: BEFORE YOU START NOTE To
Page 17 and 18: CHAPTER 1: BEFORE YOU START Applica
Page 19 and 20: CHAPTER 1: BEFORE YOU START Figure
Page 21 and 22: CHAPTER 1: BEFORE YOU START Modems
Page 23: CHAPTER 1: BEFORE YOU START Orderin
Page 27 and 28: CHAPTER 1: BEFORE YOU START Storage
Page 29 and 30: D20MX Processor Chapter 2: Installi
Page 31 and 32: CHAPTER 2: INSTALLING THE D20MX Fig
Page 33 and 34: CHAPTER 2: INSTALLING THE D20MX To
Page 35 and 36: CHAPTER 2: INSTALLING THE D20MX Fig
Page 37 and 38: CHAPTER 2: INSTALLING THE D20MX Con
Page 39 and 40: D20MX Processor Chapter 3: Connecti
Page 41 and 42: CHAPTER 3: CONNECTING TO DEVICES AN
Page 53 and 54: D20MX Processor Chapter 4: Powering
Page 55 and 56: CHAPTER 4: POWERING-UP AND TESTING
Page 57 and 58: CHAPTER 4: POWERING-UP AND TESTING
Page 59 and 60: D20MX Processor Chapter 5: Configur
Page 61 and 62: CHAPTER 5: CONFIGURING THE SOFTWARE
Page 75 and 76:
CHAPTER 5: CONFIGURING THE SOFTWARE
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
D20MX Processor Chapter 6: Using th
Page 83 and 84:
To remove the D20MX from a D20 chas
Page 85 and 86:
D20MX Processor Appendix A: Default
Page 87 and 88:
APPENDIX A: DEFAULT ROLE-BASED ACCE
Page 89 and 90:
APPENDIX A: DEFAULT ROLE-BASED ACCE
Page 91 and 92:
D20MX Processor Appendix B: Standar
Page 93 and 94:
APPENDIX A: STANDARDS & PROTECTION
Page 95 and 96:
D20MX Processor Appendix C: List of
Page 97 and 98:
APPENDIX B: LIST OF ACRONYMS Acrony
Page 99 and 100:
D20MX Processor Index A AUTOMATIC O
Page 101 and 102:
INDEX SOFTWARE PREREQUISITES ......
Page 103 and 104:
Modification Record Version Revisio
show all

944-0140 D20MX Substation Gateway ... - GE Digital Energy

Create successful ePaper yourself

Delete template?

Save as template?