BM 10-XE - Buch - Wurth

BM 10-XE - Buch Seite 7 Mittwoch, 6. Dezember 2006 10:07 10GBFor Your SafetyWorking safely with this machine is possibleonly when the operating and safetyinformation are read completely and theinstructions contained therein are strictlyfollowed. In addition, the general safetynotes in the enclosed booklet must be observed.Before using for the first time, ask for a practicaldemonstration.The unit must not be damp and must notbe used in a wet environment.Wear hearing protection. Exposure tonoise can cause hearing loss.Before each use of the machine, checkthe machine, cable and plug. Haverepairs carried out only through theWürth Master-Service or by a qualifiedtechnician. Insert the plug into the socketonly when the machine is switched off.❏ When working with the machine, always hold itfirmly with both hands and provide for a securestance. The power tool is guided more secure withboth hands.❏ Secure the workpiece. A workpiece clamped withclamping devices or in a vice is held more securelythan by hand.❏ Do not work materials containing asbestos.Asbestos is considered carcinogenic.❏ Always wait until the machine has come to acomplete stop before placing it down. The toolinsert can jam and lead to loss of control over thepower tool.❏ Hold the machine with a firm grip. High reactiontorque can briefly occur while driving in and looseningscrews.❏ Do not use a machine with a damaged mainscable. Do not touch the damaged cable and pullthe mains plug when the cable is damaged whileworking. Damaged cables increase the risk of anelectric shock.❏ Connect machines that are used in the open via aresidual current device (RCD).❏ Use suitable detectors to determine if utility linesare hidden in the work area or call the local utilitycompany for assistance.Contact with electric lines can lead to fire and electricshock. Damaging a gas line can lead to explosion.Penetrating a water line causes propertydamage or may cause an electric shock.❏ Hold the machine only by the insulated grippingsurfaces, when performing an operation wherethe cutting tool may run into hidden wiring. Contactwith a “live” wire will make exposed metalparts of the tool “live” and shock the operator.❏ Use only original Würth parts and accessories.For further notes on safety refer to the enclosed sheet☞Machine ElementsThe numbering of the machine elements refers to theillustration of the machine on the graphics page.1 Keyless chuck2 Auxiliary handle collar3 Ventilation slots4 Rotational direction switch5 Lock-on button6 On/Off switch7 Latch for mains cable module8 Securing screw9 Allen keyNot all of the accessories illustrated or described are includedas standard delivery.Intended UseThe drill can be used for drilling in wood, metal andplastics and for screwdriving.The user is responsible for damage caused by usageother then intended.Noise/Vibration InformationMeasured values determined according toEN 60 745-1.Typically the A-weighted sound pressure level of theproduct is 79 dB (A). The noise level when working canexceed 90 dB(A). Measurement uncertainty K=3 dB.Wear hearing protection!The typical hand-arm vibration is below 2.5 m/s 2 .7