DAZZLER RTR - Tamiya

2WD Buggy DAZZLERAdjusting the carburettorCarburettor inlet1 - 1,5 mmThe carburettor is already factory set ready to run.No further adjustment or break-in is necessary before starting the engine.Adjustment may change according to the fuel and plug to be used as well asto the weather conditions such as air density and humidity.To adjust the throttle/brake lever loosen the grub screw of the rod stopperand reposition them.Adjusting the idle speed mix adjusting screwA visual check of the carburettor inlet is possible after removing or beforeattaching the air filter.Carburettor inlet1 - 1,5 mmThe gap is adjusted to 1~1.5mm at the factory and set to a slightlyincreased RPM for easy starting.Main nozzle needleidle speed mixadjusting screwAdjusting the idle speed mix adjusting screw to fuel and plug.- For high idling turn right / screw-in idling mix adjusting screw.- For low idling, turn left / unscrew the screwAdjusting the main nozzle needleMaximum RPM (revolutions per minute) is adjusted with the main nozzleneedle.- Turning clockwise will give increasing RPM and- turning counterclockwise will give decreasing RPM.Turning clockwise too much for high RPM can cause reduced lubricationand overheating with damage to the inside of the engine.For the first drive use the factory-set adjustment of the needle!FuelingModel engines are self-lubricating. The oil part in the fuel ensures thelubrication of the engine.Only use fuel for model car engines.- The percentage of oil in e.g. plane engine fuels is too low(too little lubrication)RecommendationIn the break-in phase, a special RC car fuel with max.10% nitromethaneshould be used (Carson fuel No. 13934).After the regulary break-in you can change to a fuel with16% nitromethane (Carson fuel No. 13935/6),under racing conditions use a 25% nitromethane fuel(Carson fuel No. 13937/8)- Close tank cap tightly after filling in fuel.30WWW.CARSON-MODELSPORT.COM