DAZZLER RTR - Tamiya

2WD Buggy DAZZLERRC-systemTransmitter does not work properlyTransmitter range is too smallServos do not work properlyRC transmitter does not work wellwhile the engine is runningTransmitter and/or receiver batteries areemptyBatteries are inserted wrongPlug from the receiver battery is loosePoor receptionTransmitter and/or receiver batteries are tooweakTransmitter antenna is not pulled outcompletelyReceiver antenna is not pulled out completelyReceiver antenna is cutTransmitter and/or receiver batteries are tooweakGear wheels inside the servo gear do notengage or are defectiveAdjusting ring at the steering levers are looseReceiver crystal is loosePlug from the receiver batteries is loosePoor receptionReceiver damaged, e.g. after a crashReplace the transmitter and/or the receiverbatteriesTest the polarity of the batteriesPlug-in the plug firmlyReceiver antenna is not pulled out completelyReplace the transmitter and/or the receiverbatteriesPull out the antenna completelyPull out the antenna completelyLet repair the receiver antennaReplace the transmitter and/or receiver batteriesLet repair the servoFix the adjusting rings again, use the standardsettingsPut-in the receiver crystal againPlug-in the plug againReceiver antenna is not pulled out completelyRepair the receiverChassisModel pulls to one side Steering trim is misaligned Correct the neutral position on the remote controlModel can be controlled but onlywith difficultyAlignment right and left is different Reset the alignment on both sides to 0degrees.Wheel damaged on one side or bearingsdefectiveServo links not properly adjustedReceiving power of the antenna is too smallBatteries of transmitter and/or receiver emptyRemove the wheel, clean the bearings and, ifnecessary, replacePlace servos in neutral position and readjustPull out the antenna of the transmitter completely.Completely unwind the antenna of the receiverand guide it upwardsReplace batteries or recharge rechargeable batteriesPoor braking Brake linkage misaligned Correct the adjustment of the brake steering leverBrake disc worn out Replace brake diskClutch does not engage Clutch shoes worn out or defective Replace clutch shoesClutch bell worn out or defectiveFly wheel is looseReplace clutch bellRetighten fly wheel.Clutch does not disengage Spring for clutch shoes worn out or defective Replace springsModel does not function Main pinion defective Replace main pinionDamaged pinions in the differentialCentrifugal clutch set too looseReplace pinionsReset centrifugal clutchDamping not functioning One or more dampers are jammed Clean and/or disassemble dampersPiston rod bentRepair the piston rodShock absorbers lose oil A damping component is defective Check and replace the corresponding partModel rolls over towards the backduring accelerationSealings worn outCentrifugal clutch set too tautReplace sealingsLoosen the adjusting screw until the model runssmoothlyNo. 10300309/0637