Template BA B168xH238 - All4gates

ENGLISHUse protective glovesAudible engagementDIL switch factory settingFitting, maintenance, repairs, and disassembly of the doorsystem and garage door operator must be performed by aspecialist.▶ In the event of a failure of the garage door operator, aspecialist must be commissioned immediately for theinspection or repair work.2.5 Safety instructions for fittingThe specialist carrying out the work must ensure thatinstallation is conducted in compliance with the prevailingnational job safety rules and regulations and those governingthe operation of electrical equipment. The relevant nationaldirectives must be observed. Potential hazards as outlined inDIN EN 13241-1 are avoided by construction and fittingaccording to our guidelines.The garage ceiling must guarantee secure fastening of theoperator. For ceilings which are too high or too light, theoperator must be fastened on additional struts.2 Safety instructions2.1 Intended useThe garage door operator is intended exclusively for theimpulse operation of spring-compensated sectional doorsand up-and-over doors in the private/non-commercial sector.Note the manufacturer's specifications regarding the door andoperator combination. Potential hazards as outlined inDIN EN 13241-1 are avoided by construction and fittingaccording to our guidelines. Door systems that are located ina public area and only have one protective device, such as aforce limit, may only be operated under supervision.The garage door operator is designed for operation in dryareas.2.2 Inappropriate useContinuous operation and use in the commercial sector isprohibited.The operator must not be used for doors without a safetycatch.2.3 Fitter qualificationOnly correct fitting and maintenance in compliance with theinstructions by a competent/specialist company or acompetent/qualified person ensures safe and flawlessoperation of the system. According to EN 12635, a qualifiedperson is a person with suitable training, specialist knowledgeand practical experience sufficient to correctly and safely fit,test, and maintain a door system.2.4Safety instructions for fitting, maintenance,repairs and disassembly of the door systemdangerCompensating springs are under high tension▶ See warning in section 3.1WARNINGDanger of injury due to unexpected door travel▶ See warning in Section 7Mains Voltage▶ See warning in section 4Unsuitable fixing material▶ See warning in section 3.6Danger to life from the rope▶ See warning in section 3.6dangerWARNINGDanger of injury due to unwanted door travel▶ See warning in section 3.6CAUTIONCrushing hazard during boom fitting!▶ See warning in section 3.52.6Safety instructions for initial start-up andoperationWARNINGDanger of injury during door travel▶ See warning in section 6Danger of injury by fast-closing door▶ See warning in section 6.2.1Crushing hazard in the boom▶ See warning in section 6CautionDanger of injury from the cord knob▶ See warning in section 6Danger of injuries due to the hot lamp▶ See warning in section 6 and 7.2TR10L003-A RE / 06.2010 21