Kalzip® zipping machine

9. Checking the settings
1. Clean the closure surfaces. Adjust the tension bars
(6, DDF 7-0) by means of the two nuts (DDF 7-1) such
that the machine can be completely closed.
2. Check that all guide rollers (6, DDF 3-6; DDF 5-3;
DDF 4-1) move freely and are correctly adjusted.
3. Perform a trial zipping operation
10. Available roller sets
• for 0.7 - 1.0 mm, nom. 0.7 – 1.0
• for 1.2 mm, nom. 1.2
• for translucent sheets, nom. L
Wrong fixing of the various roller sets is under normal
circumstances not possible. Always use all four rollers
of one type. Tools required to change the roller set:
Ring spanner 19 mm
11. Curved Kalzip profi led
sheet
Modification of the zipping machine may be necessary for
working on curved Kalzip profiled sheets.
• Crimp-curved sheets:
Contact rollers (6, DDF 3-12) must be always removed.
• Roll-curved sheets:
The guide rollers (6, DDF 4-0) must be removed if the
radii are less than 2 m.
12. Double skin translucent sheets
The guide rollers must be removed.
13. Repairs
Repairs to and inside the casing may only be
carried out by the machine manufacturer. Repairs
carried out by the user render the warranty void.
The manufacturer accepts no liability for repairs
carried out improperly and any damage resulting
therefrom.
Kalzip zipping machine
Kalzip 35
Deutsch
Español Italiano Français English