Plast Coat PC 25 PC 35 - WAGNER-Group

Plast Coat 25 · 35GBPlacing into operation 85 7• Fill 2–3 l synthetic resin dispersion or cellulose paste into thereceptacle.• Caution: set changeover switch (4, fig. 14) to „0“ before turningon the master switch (1, fig. 14).The pump is switched on, even if the feed rateregulator is at position „0“.321 6Extension cable PlastCoat 25The cross section of the cable must be min.3 x 2.5 mm. Unwind extension cable completely.Make sure that the couplings andplugs are in complete working order.4• Turn master switch (1, fig. 14) to „1“, the indicator lamp willshow that the machine is ready for operation.• Set feed rate regulator (3) to „5“.• Turn changeover switch (4) to „AUTO“ (remote control usingspray lance).• Hold spray lance over an empty bucket.Extension cable PlastCoat 35The cross section of the cable must be min.5 x 2.5 mm. Unwind extension cable completely.Make sure that the couplings andplugs are in complete working order.Arrange the mains cable so that there is nodanger of it being tripped over.Protect against damage, e.g., caused by itbeing run over.1234• Before connecting to the mains make sure that the mainsvoltage is in accordance with the details on the ratingplate.• Only connect to the mains supply using a special distributingpoint, e.g. using a site distribution system with fault currentprotection with INF ≤ 30 mA.• Connect mortar spraying machine to the mains supply.Preparing the mortar spraying machineOnly work with the safety grill inserted!Recommended lubricant for the mortar hoseWater is not a satisfactory lubricant.Danger of blockages!Synthetic resin products –> synthetic resindispersionPCC systems–> cellulose pasteSpray lance with automatic control• Open material tap (3, fig. 15) on the spray lance. The mortarspraying machine will switch on.Spray lance without automatic control• Open material tap (3, fig. 16) on the spray lance. Press remotecontrol switch (1, fig. 16). The mortar spraying machine willswitch on.Spray lance with automatic control• When the synthetic resin dispersion or cellulose paste hasbeen pumped into the mortar hose – turn off device, turnswitching sleeve (1, fig. 15) by 90° in a clockwise direction asfar as it will go.• Close material tap (3, fig. 15).37