Temperatur - Vintec and Transtherm

Temperature settings for 3 temperature modelsThe temperature control(s) and setting(s) are adjusted from your wine cabinet’ssettings panel, as shown below:Chilling temperaturedisplayHot circuit indicator light(Red)Maturing temperaturedisplayLighting ON /OFFswitchGeneral ON / OFFswitchLighting (LED1)Servicetemperature switchKeyboardLighting (LED2)Cold circuit indicator light(Green)3 temperature cabinet models have 3 zones:• The first “low” zone, called the chilling compartment. Its original settemperature is 7°C (44°F), on leaving the factory.It is possible to adjust the temperature setting. Please note, however, thatthere is no upper or lower limit.Please note: Its recommended setting range is 6°C to 8°C (42°F to 46°F).To adjust the temperature of your chilling zone:Please note: Once you see the display flash during setting, you have 50 seconds tochange or confirm your setting, otherwise you will have to restart the process.If the setting has not been recorded, your cabinet will retain its original settings.Press and hold down the key for 5 seconds. “St” will appear on the display.Press , “F4” will appear on the display (“F4”: chilling compartment temperaturesetting).Press to read the set temperature.Press to increase the set temperature, orPress to reduce the set temperature.To record your setting, press the button and hold for 5 seconds until thetemperature is displayed.Otherwise, it will be necessary to restart the process.Pressing! for5 secondsallows youto access:« ST »« F4 »“ST” allows you to set the winematuring temperature (for 1 and 3temperature models) or the uppersection (for multi-temperaturemodels).Allows you to change from “ST” to “F4” then “H4”.“F4” Allows you to set the temperatureof the chilling compartment (for3 temperature models) or the lowersection (for multi-temperaturemodels)Allows you to change from “ST” to “F4” then “H4”“H4” Allows you to activate or disablethe warning alarm, if a malfunc-« H4 »tion occurs.Pressing Set: Allows you to readthe set temperature of the “ST”setting.Pressing Set twice: Allows you toreturn to the “ST” displayPressing Set: Allows you to readthe set temperature of the “F4”setting.Pressing Set twice: Allows you toreturn to the “F4” display.Pressing Set: Allows you to readthe “H4” setting value:H4=O means that the warningalarm is active.H4=1 means that the warningalarm is disabledPressing Set twice: Allows you toreturn to the “F4” display.P10