D:\Documenti\Manuali\Elettrobar\La50 Elettrobar\2 ... - Diskbolaget

INSTRUCTION MANUAL FOR DISHWASHERSGB4.7 Removal of integral filter1. Turn off the machine.2. Place the wash and rinse arms at a right angle to the edgeof the door (Fig.5 ).3. Raise each semi-filter, grasping it by the handle.4.8 Emptying the machine4.8.1 Machine without drain pump‣ Turn off the machine.‣ Remove the integral filter (Fig.5 ).‣ Extract the overflow by pulling upwards (Fig.6 B ), and wait for the tub to draincompletely.If necessary, extract the tub filter and clean (Fig.6 C ).4.8.2 Machine with drain pump‣ With the machine on (Fig.7 ), press the PROGRAMME SELECTION button (2)until the DRAIN CYCLE indicator light (5) comes on.‣ Remove the integral filter(Fig.5 ).‣ Extract the overflow (Fig.6 B ).‣ Press the START button (3). Machine draining starts and the indicator light flashes.‣ The machine turns off at the end.If necessary, extract the tub filter and clean (Fig.6 C ).4.9 Resin regenerationIn machines with internal softener (available on request), when the REGENERATION indicatorlight (8) flashes rapidly (Fig.8), you need to run a resin regeneration cycle to restore properoperation of the internal softener.Proceed as follows:• Empty and clean the machine.• Open the salt container of the tub after removing the integral filter.• Pour approx. 300 g of regeneration salt into the container (kitchen salt without additives in 1 or2-mm diameter granules).• Close the container again firmly.• Make sure that the overflow has been removed.• Close the door and turn on the machine.• Use the PROGRAMME SELECTION key (2) to select the resin regeneration cycle (theREGENERATION indicator (8) turns green ).• To start the cycle, press the START button (3) (the REGENERATION light (8) flashes ). Theregeneration cycle starts and continues for about 20 minutes .• The machine turns off when the cycle ends.Page 7 of 10