RADIO CONTROLLED KOAXIAL HELICOPTER RTF - Tamiya

GBf. Flight operationSwitching on the modelEnsure sufficient space in order to undertake the first flightexperiments. Even if the helicopter can later be flown in thesmallest quarters, it requires about 3m free space in all directions.• Set the model on a smooth and level surface, so that thehelicopter can freely glide and lift off.• Set the helicopter about 2 m in front of yourself on theground, the tail pointing towards you. This way the directionof reaction of the helicopter conforms to the direction ofcontrol.• Unwind the receiver antenna completely and fastenthe aerial wire with an adhesive strip to the fuselage fortraction relief.Pull the transmitter antenna totally out.The effective range of the remote control is reduced if theantenna is not completely pulled out.• Pull the left remote control lever (pitch) totally back.• Take care that the pitch function of the trim lever isapproximately in the middle position.• Switch the transmitter on.• Now connect thecharged airplanebattery to thereceiver.2 mThe LED (1) on the receiver begins to blink. This indicates thatthe electric circuit of the electronic gyro is calibrating itself.The model may now not be moved!When the process is concluded and the receiver is receivingcorrect signals the LED lights up continuously.If the LED blinks slowly, then the battery voltage is too low.Recharge the battery or replace it with an original replacementbattery!Bring all control levers into the neutralposition.• Move the left control lever slightly forward, until the modeljust lifts off from the ground.• Pull the control lever slowly back again, so that the modelgently alights.Move the control extremely delicately!Check the effective range of the remotecontrol transmitterBefore every first start or after a crash, check the function andeffective range of the RC equipment!In the neutral position of the control lever of nick and roll, thewobble plate should also be in neutral position.If this is not the case, correct the position with the trim levers ofthe respective control channel on the transmitter.• Move slowly away from the model (motor is not running!).• Consecutively press the remote control levers nick and rolland• observe the reactions of the model.The RC equipment works faultlessly if from about 30 mdistance the model still correctly responds to the remotecontrol signals. The maximum range of the transmitter is about100 m.Never drive the model if the remote control does not workproperly! A malfunction of the radio may cause damage to themodel, property and/or serious injury.18CARSON Helikopter EC-135 Rescue 50 050 7031