MCS 50
MCS 50
MCS 50
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3. Installation of <strong>MCS</strong> <strong>50</strong> and Microphone Units<br />
3.1 Single Cable Connection<br />
3.2 Branch Cabling<br />
1. Before connecting the <strong>MCS</strong> <strong>50</strong> to the mains, please check<br />
the supply voltage (refer to chapter 4. “Supply Voltage”).<br />
2. Address the microphone units as described in the chapter<br />
1.3 “Addressing the microphone units”.<br />
3. Connect the first microphone unit to the line input of the<br />
<strong>MCS</strong> <strong>50</strong> discussion control unit. The other microphone<br />
units are connected according to the single cable principle,<br />
i.e. the second microphone unit is connected to the first<br />
one, the third to the second one etc.<br />
4. It is possible to connect up to 32 microphone units in one<br />
line to the <strong>MCS</strong> <strong>50</strong>/32 and up to 64 microphone units in<br />
two lines to the <strong>MCS</strong> <strong>50</strong>/64.<br />
1. Before connecting the <strong>MCS</strong> <strong>50</strong> to the mains, please check<br />
the supply voltage (refer to chapter 4. “Supply Voltage”).<br />
2. Address the microphone units as described in the chapter<br />
1.3 “Addressing the microphone units”.<br />
3. Connect a 15-pin Sub-D cable to the line input of the<br />
<strong>MCS</strong> <strong>50</strong> discussion control unit. Connect a CA 1513<br />
triple distributor to the other end of the cable. Connect<br />
two microphone units to the CA 1513 triple distributor.<br />
The last triple distributor in the line allows to connect<br />
3 microphone units.<br />
4. It is possible to connect up to 32 microphone units in one<br />
line to the <strong>MCS</strong> <strong>50</strong>/32 and up to 64 microphone units in<br />
two lines to the <strong>MCS</strong> <strong>50</strong>/64.<br />
Note:<br />
The total length of the bus cable must not exceed 300 m. Each branch cable in this installation must not exceed 5 m.<br />
Safety instructions<br />
Make sure that the <strong>MCS</strong> <strong>50</strong> discussion control unit is always switched off when connecting, disconnecting or addressing the microphone<br />
units.<br />
4. Supply Voltage / Power Supply<br />
The power supply unit has been developed for an input voltage of 85 V to 264 V AC (<strong>50</strong>/60 Hz).<br />
Caution:<br />
If the F101 fuse of the integrated power supply (refer also to No. 200 in “Exploded View and Spare Parts, <strong>MCS</strong> <strong>50</strong> Discussion Control Unit”, page 48<br />
to 49) is defective, you should replace the whole part. A different fuse with a higher value than 6.3 A can destroy the power supply.<br />
Please contact your beyerdynamic-dealer.<br />
35<br />
english
Change language