xtp110 lumilinko snöslunga snow thrower - Virtasenkauppa.fi

- Run engine until fuel tank is empty and engine stops due to lack of fuel.- Drain carburetor by pressing upward on bowl drain, located below the carburetor cover.NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits duringstorage. Do not drain carburetor if using fuel stabilizer.- Wipe equipment with an oiled rag to prevent rust.- Remove spark plug and pour one ounce of engine oil through spark plug hole into cylinder. Cover sparkplug hole with rag. Crank engine several times to distribute oil. Replace spark plug.- Follow the lubrication recommendations found in the Maintenance Section.- Always store the snow thrower in a clean, dry area.NOTE: When storing any type of power equipment in an unventilated or metal storage shed, care should betaken to rust proof the equipment. Using a light oil or silicone, coat the equipment, especially any chains,springs, bearings and cables.SECTION 8: TROUBLESHOOTINGProblem Cause RemedyEngine failsto startEngine runserraticEngineoverheatsLoss ofpowerExcessivevibrationUnit fails toself-propelAugerscontinue torotate1. Fuel tank empty or stale fuel.2. Blocked fuel line.3. Spark plug wire disconnected.4. Faulty spark plug.5. Engine flooded from excessive priming.6. Engine flooded from excessive priming.7. Throttle is in the Stop Position.8. Ignition key not snapped in place.1. Unit running on choke.2. Fuel line blocked, or stale fuel.3. Water or dirt in fuel system.4. Carburetor out of adjustment.1. Fill tank with clean fresh gasoline.2. Clean fuel line.3. Connect wire to spark plug.4. Clean spark plug. Re-adjust gap, orreplace.5. Prime engine four times.6. Wait at least ten minutes beforestarting.7. Move throttle lever to the Rabbitposition.8. Insert ignition key. See: “Ignition Key”section.1. Move choke lever to OFF position.2. Clean fuel line and fill tank with fresh,clean gasoline.3. Refer to Engine Maintenance section.4. Refer to Engine Maintenance section.1. Carburetor out of adjustment. 1. Refer to Engine Maintenance section.1. Spark plug wire loose.1. Firmly connect spark plug wire.2. Vent in gas cap plugged.2. Clear vent.1. Loose parts or damaged auger. 1. Stop engine immediately anddisconnect spark plug wire. Check forpossible damage. Tighten all bolts andnuts. Repair as needed. If the problempersists, take unit to an authorizedservice dealer.1. Drive belt loose or damaged. 1. Replace drive belt.1. Cable out of adjustment. 1. Adjust auger control cable as shown in“Adjusting Auger Cable” section.69