1 - Hjallerup Maskinforretning A/S

SELECTO-FIX
Description
SELECTO-FIX is an equipment allowing easy connection
/ disconnection of the implement hydraulics.
SELECTO-FIX MK3 is adapted to fit loaders equipped
with SELECTO MK3.
SELECTO-FIX is available in two designs:
1) SELECTO-FIX (3) is aimed for the connection of
implements with one doubleacting hydr. function.
Ref.No 301607 (loader part - to be fitted on the valve)
Ref.No 301605 (implement part - to be fitted on the
hydraulic hoses from the implement).
These kits are also used in combination with
SELECTO (3+4) when the loader is equipped with
hydraulic implement locking. This means that the
hoses to the hydr. locking are permanent.
2) SELECTO-FIX (3+4) is aimed for the connection of
implements with two double acting hydr.functions.
Ref.No 301608 (loader part)
Ref.No 301606 (implement part)
ENGLISH (114-501)
Each hydraulic implement shall be equipped with kit
301605 or 301606.
Remark ! concerns loaders equipped with hydraulic
implement locking - the hoses from the hydraulic implement
locking shall NOT be connected via the SELECTO-
FIX implement part. Use kit 301605. This means that
only implements with one double-acting function can be
connected if the loader is equipped with hydraulic
implement locking.
Kit 301607 (for the loader) consists of:
1 Coupling part with two quick couplings (F)
6 Screws MC6S 8 x 60
4 "O"-rings
Kit 301605 (for the implement) consists of:
1 Coupling part with two quick couplings (M)
Kit 301608 (for the loader) consists of:
1 Coupling part with four quick couplings (F)
6 Screws MC6S 8 x 60
4 "O"-rings
Kit 301606 (for the implement) consists of:
1 Coupling part with four quick couplings (M)
MOUNTING OF LOADER PART
Fig. A
(concerns loaders equipped with SELECTO (3)
Remove existing quick couplings / plugs from the front of
the valve.
Secure the SELECTO-FIX loader part to the valve.
Please note the position of the seals (o-rings).
Fig. B
(concerns loaders equipped with SELECTO 3 + 4)
Remove existing quick couplings from the front of the
valve.
Secure the SELECTO-FIX loader part to the valve.
Please note the position of the seals (o-rings).
MOUNTING OF IMPLEMENT PART
Fig. C1
On loaders equipped with hydraulic implement locking,
the quick couplings shall be screwed on to the
SELECTO-FIX loader part (remove existing plugs).
NOTE ! use kit 301605.
Fig. A1, B1, C1
- Remove existing quick couplings from the hydraulic
hoses of the implement.
- Connect the hoses. Check that the movement of the
implement corresponds to the lever movement desired
(control valve). The connection of the hoses to the
coupling part can be inversed (if required).
A
B
C
A1
B1
C1
- REMARK !! check that the length of the hoses is
sufficient at max. dumping movement -at a height of
about 1,5 m.
114