BRUSA Elektronik AG info@brusa
BRUSA Elektronik AG info@brusa
BRUSA Elektronik AG info@brusa
Sie wollen auch ein ePaper? Erhöhen Sie die Reichweite Ihrer Titel.
YUMPU macht aus Druck-PDFs automatisch weboptimierte ePaper, die Google liebt.
Betriebsanleitung BSC624-12V User’s manual BSC624-12V<br />
7 Inbetriebnahme des Gerätes<br />
Start-up the device<br />
7.1 Befestigung des Geräts im Fahrzeug<br />
Mounting of the device in the vehicle<br />
Befestigungslöcher (Tiefe 11mm) mit<br />
Gewinde M5x11<br />
Mounting holes (depth 11mm) with<br />
thread M5x11<br />
Befestigungslöcher (Tiefe 15mm) mit<br />
Gewinde M5x15<br />
Mounting holes (depth 15mm) with<br />
thread M5x15<br />
• Bevor das Gerät in Betrieb genommen werden kann,<br />
müssen folgende Tätigkeiten durchgeführt werden.<br />
Nehmen Sie sich Zeit dafür und lesen Sie die Anleitung<br />
gründlich durch. Die Arbeiten dürfen nur durch<br />
einen Fachmann durchgeführt werden.<br />
• Das Gerät verfügt auf der Unterseite über 6 Befestigungslöcher<br />
mit einer Tiefe von 15mm mit folgenden<br />
Daten hinsichtlich Gewinde:<br />
4 Montagelöcher mit Gewinde M5x11<br />
2 Montagelöcher mit Gewinde M5x15<br />
• Das Gehäuse ist für Befestigungsdrehmomente bis<br />
5Nm ausgelegt.<br />
• Wir empfehlen die Verwendung von Schrauben der<br />
Festigkeitsklasse 8.8, die mit einem Drehmoment von<br />
5Nm angezogen werden.<br />
BSC624-12V_User_Manual_090615.doc 31 / 41<br />
• Before the device can be taken into operation following<br />
steps have to be done. Take your time for it<br />
and read the manual carefully. The mounting work<br />
has to be done by an expert.<br />
• The device has 6 mounting holes with a depth of<br />
15mm at the bottom, whereas these have following<br />
specification regarding the thread:<br />
4 mounting holes with thread M5x11<br />
2 mounting holes with thread M5x15<br />
• The housing is specified for mounting torques of<br />
up to 5Nm.<br />
• We recommend the use of screws with a strength<br />
class of 8.8, which can be mounted with a torque<br />
of 5Nm.