EN Installation and operation instructions for RADEMACHER X-line ...

Roller shutter control
Alarm object
Menu Settings
Use alarm object No · Yes
If „Yes“: If alarm object value = 1
If alarm object value = 0
no action · stop · up-command · down-command
◆ In case of manual operations before and after alarm no action · move to last position
◆ In case of automatic operation after alarm Follow automatic
Value of the object before 1st communication and restoration of bus voltage 0 · 1
Blocking object 1 / 2
Menu Settings
Use blocking object 1 No · Yes
If „Yes“: If blocking object value = 1 no action · stop · up-command · down-command
If blocking object 1 value = 0
◆ In case of manual operations before and after blocking no action · move to last position
◆ In case of automatic operation after blocking Follow automatic
Value of the object before 1st communication and restoration of bus voltage 0 · 1
Use blocking object 2 No · Yes
If „Yes“: Use settings “blocking object 1” see „Blocking object 1“
Wind block
Menu Settings
Use wind block
NOTE
When blocking, the roller shutter moves up.
No · Yes
If „Yes“: Type of input object 1 Bit · 16 Bit
If „1 Bit“: Waiting time in safe position in min. after wind block 0 … 255
Behaviour after waiting period:
◆ In case of manual operation before and after wind alarm no action · move to last position
◆ In case of automatic operation after blocking Follow automatic
If „16 Bit“: From wind speed in m/sec up-command 2 … (5) … 30
Waiting time in safe position in min. after wind alarm 0 … 255
Behaviour after waiting period:
◆ In case of manual operation before and after wind alarm no action · move to last position
◆ In case of automatic operation after blocking Follow automatic
Send current blocking status No · Yes
EN
69