Revox C274 - Revoxsammler

sruotrR nd/ox tr274 2
Ls"D.n s*c_!j-rr s _ t.h-e--. .-e_u"-d*i"_o-,'_i-n-p--q"t-"r_ ._ _an_d. _"9---u_"t.p."1'|"-t.F.".........."
The recorder hag one balanced input and output +6r
each channel. I+ you prepere your own cablesr tnake
sure that the wiring i5 correct. I+ the balanced
inputs and outputs ar€r connected to the equipment
with unbalanced signal mänege,$entr the cold ends
must be connected to the screening (refer to technical
apFendix). hlhenever possiblet balanced signal
nanagement =hould
be used.
'@1 '1@'nEc268 14
INPUT
OUTPUT
F*lt.t"s-hJn-s-..*o-n *-ti.F*-.-t*q,p-e*-.r--e-q-er*d-e-r -.-... - - -,
trlhen you press the PBUJER tll key on the front
panel, the tape recorder switches on. Press the
same key again and the machine switcheg off. Nhen
yeu switch on the tape recorder. the tape speed in
"ips" tinches per second) and subsequently the content
of the real-time counter are shown on the
display t7l. In eddition the lagt selected paremeterg
Äre signalled by LEDs. I+ the tape =peed
remäi.ns on the display a{ter the recarder has been
switched on and i{ the other LEDs are dark. the
battery is either run down, or no battery is installed.
or the DIP switch E behind the operatin-o
section is not in the ON position. This means thet
the counter content and the last active system
parameters are lost. The recorder eeteblishes a
basic setting: ltrer tape speed, READY r:f+! counter
and address locetor et zero, etc. The speed indication
remains on the display t71 until any key is
pressed.