Becker Centronic MemoControl MC511 Anleitung - auf enobi.de

Weitere Magazine

Empfehlungen

Info

Assembly and Operating InstructionsDisplays and pushbuttonsUP pushbuttonSTOP pushbuttonDOWN pushbuttonMC511Battery compartmentProgramming pushbuttonTransmission control light+Sliding Switch+FunctionsSliding SwitchEvery PRF+ tubular drive can store switching times for one UP and one DOWNcommand.In the „ “ operating mode this roller shutter command is repeated every 24hours.The sliding switch setting is not important when learning the switching time. Allpreviously stored switching times are deleted.14
Programming the switching times1. Adjust the roller shutters, if necessary, until they are in the opposite end positionto the desired running direction.2. Wait for the automatic control commands are to be executed.3. At the preset time, activate the desired direction key and hold down until theroller shutter system has stopped after approximately 6 seconds and thenmoved into the end position.4. Release direction key.The tubular drive will store the given time of this direction command.Follow the same procedure for the opposite direction.When the sliding switch is set to manual, no automatic control commands areexecuted. The stored command times remain unaltered.Deleting the switching timesNoteBoth switching times are always deleted in this process.In order to delete the times the UP and DOWN control commands are to be triggered,press the STOP button for 10 seconds. This is acknowledged by a doubleclick of the tubular drive.The switching times have been deleted.Transmission control lightA radio signal is indicated by the transmission control light being lit.If the battery starts running out, the transmission control light lashes duringtransmission.The transmitter power and/or radio range is reduced when the battery is runninglow. If the transmission control light is no longer lit when the pushbutton ispressed, the batteries must be changed.ChannelThe channel of a handheld transmitter can be programmed into one or severalreceivers. One or several receivers are controlled via an individual or group commandrespectively.deenfrnl15
Seite 1 und 2: CentronicMemoControl MC511deenfrnlM
Seite 3 und 4: SommaireGénéralités ............
Seite 5 und 6: Bestimmungsgemäße VerwendungDer M
Seite 7 und 8: Programmieren der Fahrzeiten1. Ggf.
Seite 9 und 10: 7Montage Wandhalterung1626• Prüf
Seite 12 und 13: Assembly and Operating Instructions
Seite 20 und 21: Notice de montage et d’utilisatio
Seite 28 und 29: Montage- en gebruiksaanwijzingAlgem
Seite 30 und 31: Montage- en gebruiksaanwijzingVerkl
Seite 32 und 33: Montage- en gebruiksaanwijzingProgr
Seite 34 und 35: Montage- en gebruiksaanwijzingTechn
Seite 36: Becker-Antriebe GmbH35764 Sinn/Germ

Becker Centronic MemoControl MC511 Anleitung - auf enobi.de

Erfolgreiche ePaper selbst erstellen

Template löschen?

Als Template speichern?