Becker Centronic MemoControl MC511 Anleitung - auf enobi.de

Programming the switching times1. Adjust the roller shutters, if necessary, until they are in the opposite end positionto the desired running direction.2. Wait for the automatic control commands are to be executed.3. At the preset time, activate the desired direction key and hold down until theroller shutter system has stopped after approximately 6 seconds and thenmoved into the end position.4. Release direction key.The tubular drive will store the given time of this direction command.Follow the same procedure for the opposite direction.When the sliding switch is set to manual, no automatic control commands areexecuted. The stored command times remain unaltered.Deleting the switching timesNoteBoth switching times are always deleted in this process.In order to delete the times the UP and DOWN control commands are to be triggered,press the STOP button for 10 seconds. This is acknowledged by a doubleclick of the tubular drive.The switching times have been deleted.Transmission control lightA radio signal is indicated by the transmission control light being lit.If the battery starts running out, the transmission control light lashes duringtransmission.The transmitter power and/or radio range is reduced when the battery is runninglow. If the transmission control light is no longer lit when the pushbutton ispressed, the batteries must be changed.ChannelThe channel of a handheld transmitter can be programmed into one or severalreceivers. One or several receivers are controlled via an individual or group commandrespectively.deenfrnl15