MVME5500 Single-Board Computer Installation and Use - Bustec

1
Hardware Preparation and Installation
J20 CPU COP Enable Header No jumper installed
[1-2]
J25 PCI Bus 0.0 Speed Header [No jumper installed]
1-2
J27 VME SCON Select Header No jumper installed
1-2
[2-3]
J28, J32 PMC/SBC Mode Selection
Headers
(set both jumpers)
Warning: Refer to page
1-9 for a warning about
configuring for IPMC
mode.
1-2 on both
2-3 on both
[2-3 on J32, 1-2 on
J28]
J29 PCI Bus 1.0 Speed Header [No jumper installed]
J30 EEPROM Write Protect
Header
J34,
J97,
J98, J99
J102 –
J110
Table 1-2. MVME5500 Jumper Settings (continued)
Jumper Function Settings
Ethernet 2 Selection
Headers
(see also J6, J100, J7, J101)
Note Refer to a note on
page 1-8 for a configuration
limitation.
1-2
No jumper installed
[1-2]
P2 I/O Selection Headers 1-2
[2-3]
Enables boundary scan
Enables CPU COP
PMC board controls whether
the bus runs at 33 MHz or
66 MHz
Forces PCI bus 0.0 to remain at
33 MHz
Always SCON
No SCON
Auto-SCON
PMC mode
SBC/IPMC761 mode
SBC/IPMC712 mode
PMC board controls whether
the bus runs at 33 MHz or 66
MHz
Forces PCI bus 1.0 to remain at
33 MHz
Disables EEPROM
programming
Enables EEPROM
programming
1-2 on all Rear P2 Ethernet
(set when in SBC/IPMC761
mode)
[No jumpers Front-panel Ethernet
installed]
PMC 2 I/O connected to P2
IPMC I/O connected to P2
1-6 Computer Group Literature Center Web Site