What's New in StruCad V12 - Computer Control Systems
What's New in StruCad V12 - Computer Control Systems
What's New in StruCad V12 - Computer Control Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
The World’s Lead<strong>in</strong>g 3-D Structural Steel Detail<strong>in</strong>g System<br />
Rendered Solids<br />
Rendered solid has now been <strong>in</strong>troduced to the ‘Solid Display’ <strong>in</strong> the Wire Frame. Previously<br />
only the edges of modelled solids would be displayed, now the faces are rendered to provide<br />
a true 3D solid display. The ‘Display’ Command is still used to display or un-display the solid.<br />
The <strong>in</strong>troduction of Rendered solids has necessitated several new commands and functions.<br />
The Display and UnDisplay commands function the same as previously with the exception of<br />
the new options to switch the Solid / Wire Frame on or off. These two options have been<br />
added to a new type of toolbar icon on the left hand side tool bar.<br />
SolToggle<br />
Toggles the solid rendered Display ‘On’ and ‘Off’. When the icon<br />
is depressed the Solid is visible.<br />
Toggles the wire frame display ‘On’ and ‘Off’. When the icon is<br />
WireToggle<br />
depressed the wireframe is visible<br />
When the solid display is rendered it can be difficult to use snaps for <strong>in</strong>putt<strong>in</strong>g wires or<br />
select<strong>in</strong>g member ends when apply<strong>in</strong>g end types etc. We have <strong>in</strong>troduced two modes of<br />
render<strong>in</strong>g. These modes are known as ‘Work Mode’ and ‘View Mode’. Each mode has its own<br />
sett<strong>in</strong>gs for the level shad<strong>in</strong>g or transparency. Each mode is used <strong>in</strong> different circumstances.<br />
Work Mode is used whenever a command or part of a command requires the selection of an<br />
entity or po<strong>in</strong>t. This could also be referred to as a pick mode. Hav<strong>in</strong>g a lower level of<br />
transparency makes it far easier to use a select command but stills allows for the full rendered<br />
What’s <strong>New</strong> <strong>in</strong> <strong>StruCad</strong> <strong>V12</strong> Page 7