Dynamic 3-201 - 3-218 - Marantec
Dynamic 3-201 - 3-218 - Marantec
Dynamic 3-201 - 3-218 - Marantec
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
C. Installation<br />
O 5<br />
Flange Mounting<br />
• Push the drive shaft with adapter (F) into the hollow shaft of the<br />
operator.<br />
Please observe position of the feather key!<br />
• Fix the inserted drive shaft with securing ring (E).<br />
• Push the operator with adapter onto the end of torsion spring shaft.<br />
• Fix screws (G).<br />
Mounting of the torque support:<br />
Installation in the same way as written in point 4.1.<br />
Attention!<br />
Please mount the sheet steel torque support parallelly to the<br />
operator motor without misalignment!<br />
O 6 Mounting of axle chain drive (ACD):<br />
Picture shows installation of operator on left side!<br />
B Drive shaft with securing ring and feather keys<br />
E Securing ring<br />
H Spacer of shaft<br />
6.1 Mounting to spring shaft (ø 31,75 mm or ø 40mm):<br />
Picture shows installation of operator on left side!<br />
• Insert drive shaft with spacer ring and the ACD – depending on<br />
installation on right or left side – into the hollow shaft of the operator.<br />
• Fix the inserted drive shaft with securing rings.<br />
• Push the connecting hub of the ACD onto the torsion spring shaft.<br />
Please observe position of the feather key!<br />
• Fix the inserted screws.<br />
• Assemble wall console M8 as shown in fig. 6.3.<br />
• Mount wall console M8 to the opposite side of the ACD to the operator.<br />
English Page 8