Ecocut - Drilling and turning with only one tool
Ecocut - Drilling and turning with only one tool
Ecocut - Drilling and turning with only one tool
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
58<br />
Edge chipping<br />
Built-up edge<br />
Corrective measures in the case<br />
of application problems<br />
Wear type Workpiece<br />
problems<br />
Swarf control<br />
Wear on clearance face<br />
raise, increase,<br />
large infl uence<br />
raise, increase<br />
low infl uence<br />
Type of problem<br />
Plastic deformation<br />
Vibrations<br />
Surface finish<br />
Chip too long (snarl chip)<br />
Chip too short (fragmented chip)<br />
Cutting speed<br />
Feed<br />
avoid, reduce<br />
large infl uence<br />
avoid, reduce<br />
low infl uence<br />
Corrective<br />
measures<br />
Corner radius<br />
Cutting material<br />
Tool clamping<br />
Workpiece clamping<br />
Overhang<br />
Tip height<br />
Cooling lubricant<br />
larger<br />
smaller<br />
wear resistance<br />
toughness<br />
check,<br />
optimize<br />
use<br />
Cutting values<br />
Insert selection<br />
General criteria
Change language