E10 manual.indd - Husqvarna Viking

More documents

Recommendations

Info

ZIGZAG STITCHING Turn the stitch selector dial so that the stitch display shows “C”-zigzag. Turning the stitch selector dial will increase or decrease the zig zag width. Snap on the standard foot. Function of stitch length dial while zigzaging The density of zigzag stitches increase as the setting of stitch length dial approaches “0”. Zigzag stitches are usually sewn at “2.5” or less. Dense zigzag stitches (close together) are referred to as a satin stitch. Stitch length dial 22
HOW TO SEW BUTTONHOLES Stitch length dial Preparation Select buttonhole with the stitch Selection dial. Snap on The buttonhole foot. Adjust the stitch length dial between “0.5” - “1”. The density of the stitch depends on thickness of the fabric. Note: Always test sew a buttonhole. To prepare the fabric Measure the diameter of the button and add 0.3 cm (1/8”) for the bartacks. If you have a very thick button, add more to the diameter measurement. Mark the position and length of the buttonhole on the fabric. Position the fabric so that the needle is on the mark that is furthest from you. Pull the buttonhole foot towards you as far as it will go. Lower the foot. 1. Select buttonhole with the stitch selection dial. Turn the stitch selection dial to (1) “ “. Sew at moderate speed until you reach the end mark. 2. Turn the stitch selection dial to (2, 4)“ “ and sew 5-6 bartack stitches. 3. Turn the stitch selection dial to (3) “ “ and sew the left side of the buttonhole to the mark at the end which is further from you. 4. Turn the stitch selection dial to (2, 4) “ “ and sew bar tack stitches. Remove the fabric from under the foot. Pull the upper thread to the wrong side of the fabric and knot upper and lower threads. Cut the center of the buttonhole with the seam ripper, being careful not to cut the stitches on either side. 23
Page 1 and 2: E10 USER’S GUIDE
Page 3 and 4: Congratulations! As the owner of a
Page 5 and 6: PRINCIPAL PARTS OF THE MACHINE 1. T
Page 7 and 8: ACCESSORIES 1 2 3 4 1. All purpose
Page 9 and 10: CONNECTING THE MACHINE TO POWER SOU
Page 11 and 12: TWO-STEP PRESSER FOOT LEVER When se
Page 13 and 14: WINDING THE BOBBIN Place thread and
Page 15 and 16: INSERTING THE NEEDLE Change the nee
Page 17 and 18: THREAD TENSION Basic thread tension
Page 19 and 20: REVERSE SEWING At the end of a seam
Page 21: STRAIGHT STITCHING Stitch length di
Page 25 and 26: BLIND HEM Stitch length dial For he
Page 27 and 28: 3-STEP ZIG-ZAG Stitch length dial S
Page 29 and 30: MAINTENANCE Attention: Disconnect t
Page 31 and 32: Please note that on disposal, this

E10 manual.indd - Husqvarna Viking

Create successful ePaper yourself

Delete template?

Save as template?