Split-type air conditioners Mitsubishi Electric MSZ-FH25VE, MSZ ...

11
DISASSEMBLY INSTRUCTIONS
The terminal which has the locking mechanism can be detached as shown below.
There are two types (Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not. (2) The terminal with this connector has the
locking mechanism.
Sleeve
Locking lever
11-1. MSZ-FH25VE MSZ-FH35VE
NOTE: Turn OFF power supply before disassembly.
OPERATING PROCEDURE PHOTOS
1. Removing the panel
(1) Remove the horizontal vanes.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Removal procedure
Unlock the upper and lower vanes as shown
in using a thin instrument.
Then, remove the horizontal vanes in the
direction of .
Unlock
(2) Remove the front panel. Remove the screw caps of
the under panel. Remove the screws of the under
panel.
(3) Pull out the right top corner of the right panel and
remove the right panel.
(4) Pull out the left bottom corner of the left panel and
remove the left panel.
(5) Unhook the lower part of the under panel and
remove the under panel.
OBH623
Upper and
lower vanes
34
Photo 1
Horizontal vanes
Photo 2
Left panel
Connector
Hold the sleeve, and
pull out the terminal
slowly.
Front panel
Screws of the panels
Screws of the under panel
Horizontal vanes
Right panel
Under panel