crimping, interconnecting cables, harnesses, and wiring - NASA

Status
Document
Revision
DOCUMENT HISTORY LOG
Approval
Date
Page 3 of 114
NASA-STD-8739.4 with Change 6
Description
Baseline 1998-02-08 Initial Release
- Page iii: Update URL for accessing NASA Technical
Standards. The correct URL is http://standards.nasa.gov/
- Page iii: Update references to NASA 5300.4(3J-1) and
NASA 5300.4(3M) to NASA-STD- 8739.1 and NASA-STD-
8739.2 respectively.
- Page iv: Insert Revisions page and renumber Table of
Contents accordingly.
- Para 2.1 Change citation for NHB 8060.1 to NASA-STD-
6001 and change citation for NHB 1700.1(V1) to NPR
8715.3.
- Para 3.2 Delete NHB from Acronym List and Add NPR
to acronym list
- Para 4.3 No. 4: Change sentence to “Crimping.
Stranded wire shall be used for crimping. Crimping of
solid wire is prohibited. Crimping of solder tinned
stranded wire is prohibited.”
- Para 5.7: Change address for training center to:
GSFC, Training Center, Code 300.1, 7000 Columbia
Gateway Dr., Columbia, MD. 21046
Change 1 2006-01-27 - Para 6.8: Change sentence to read: “All materials used
in vacuum or low pressure shall not release greater than
1.0 percent total mass loss (TML) and 0.1 percent
collected volatile condensable material (CVCM) when
tested in accordance with ASTM-E-595.”
- Para 6.8: Change NHB 8060.1” to “NASA-STD-6001” in
the second sentence.
- Para 7.3 No. 11 Change NHB 8060.1 to NASA-STD-
6001
- Para 9.7: Change tape “may be applied to bundle” to
“shall be applied to bundle”.
- Para 14.1 Change NHB 1700.1 to NPR 8715.3
- Para 18.2 No. 6.c: For the Insulation Resistance (IR)
Test, change “for a minimum of 1 minute, or as specified
in the test procedure” to “until a stabilized reading is
attained not to exceed 1 minute, or as specified in the test
procedure.”
- Appendix C Update the address for submitting changes
to NASA Technical Standards
(WHBIII)