CAT-300 Repeater Controller - Computer Automation Technology

3. Long Distance Enable
During autopatch dialing, the CAT-300 counts the total number of entries.
Phone numbers in excess of eight digits will be considered a long distance call
or an error in dialing. The controller will immediately terminate the
autopatch. When this channel is enabled, phone numbers that have more than
eight digits will be accepted.
4. Emergency 911 Enable
This channel must be enabled to process Emergency 911 requests. The controller
examines all three-digit entries. When this channel is enabled, 911 calls will
be permitted. The autopatch access code must precede 911.
5. User Speed Dial Enable
This channel must be enabled for the controller to process User Speed Dial
requests. A user can access any speed dial location. The voice will say:
"CALL TO W4XYZ", delay two seconds and then dial the phone number stored at
that location. Space is provided for (25) or (100) phone numbers with call
letter ID.
6. Phone Number Read Back Enable
This channel must be enabled for the controller to read-back the phone number
prior to dialing. After the repeater user enters the number, the CAT-300 will
read-back the number for verification. If the number was entered correctly, the
repeater user does nothing and in two seconds the CAT-300 will redial the
number. If the number is incorrect, the repeater user enters the autopatch
disconnect code during the two second period and the call will be terminated.
To temporarily suspend the phone number read back, key-up when the voice says:
"AUTOPATCH".
7. Autopatch Radio Mute Enable
When this channel is enabled, during an autopatch, mobile radio audio will go
directly to the telephone line and not be broadcast on the repeater's
transmitter. A series of beeps will be heard on the repeater's output when the
mobile is transmitting. This feature provides a measure of privacy during an
autopatch.
8. Autopatch Pre-Dial Enable
When this channel is enabled the CAT-300 will generate the number stored in the
pre-dial buffer," before regenerating the manually dial telephone number. This
feature is useful when the CAT-300 is connected to a business phone system and
a [9] is requires to access an outside line. This feature can also be used to
suppress caller ID if the pre-dial buffer is loaded with [*67]. Use the [*89]
programming command to enter a pre-dial number of up to seven digits. The
default pre-dial number is [9].
Zone 5 Autopatch
1. Emergency Speed Dial Enable
Space is provided for five public service phone numbers with identifications. A
user can access any emergency speed dial location. Example: the voice will
say: "CALL TO FIRE DEPARTMENT," delay two seconds and then dial the phone
number stored at that emergency speed dial location.
3-6