CAT-300 Repeater Controller - Computer Automation Technology

5. Telephone Ring Announcer Enable
When this channel is enabled, the CAT-300 will key-up the transmitter and
generate a ringing tone to indicate the repeater's phone is ringing.
Read Software Version
To read the current software version of the Program and Voice ROMs, key-up and
enter the control operator prefix code followed by [98]. Un-key and the voice
will read the software versions.
Soft Reset
To produce a soft reset, the equivalent of remotely cycling DC power, key-up
and enter the control operator prefix code followed by [99]. Un-key and the
microprocessor flags will be reset.
Load Memory Files By Telephone [DX]
In the control operator mode the CAT-300 will accept commands to read and load
memory files by telephone. To read the current memory file enter [90#]. To
load a memory file enter:
╔═════════╤════════════════════╤═════════╤════════════════════╗
║ COMMAND │ DESCRIPTION │ COMMAND │ DESCRIPTION ║
╟─────────┼────────────────────┼─────────┼────────────────────╢
║ 91# │ Load memory file 1 │ 93# │ Load memory file 3 ║
║ 92# │ Load memory file 2 │ 94# │ Load memory file 4 ║
╚═════════╧════════════════════╧═════════╧════════════════════╝
Figure 3-1
NOTE: Memory File 4 will be disabled if the CAT-300DX is configured to
support an area code and prefix number look-up table.
3-10