CAT-300 Repeater Controller - Computer Automation Technology

Repeater Sleep Timer [*602*]
This timer determines the time required for the repeater to be at rest before
the DTMF access code is required to activate the repeater. This timer is
programmable between 1.0 and 1799 seconds. When initialize, this timer will
default to 60 seconds.
Repeater Turn on Delay Timer [*603*]
When the repeater is at rest, this timer determines the time COR must be
present before the repeater will activate. This timer is programmable between
0.1 and 9.9 seconds. Example: To program this timer to 1.5 seconds, key-up and
enter [*603*15]. Un-key and the voice will say: "CONTROL OK." When
initialize, this timer will default to 1.0 seconds.
COR Drop to Courtesy Beep Timer [*604*]
This timer determines the time between loss of COR and the generation of the
courtesy beep. This timer is programmable between 0.1 and 9.9 seconds. When
initialize, this timer will default to 1 second.
Courtesy Beep to PTT Drop Timer [*605*]
This timer determines the time between the generation of the courtesy beep and
the time the repeater transmitter turns off. This timer is programmable
between 0.1 and 9.9 seconds. When initialize, this timer will default to 4
seconds.
DTMF Mute Delay Timer [*606*]
This timer determines the time the transmit audio will continue to be muted
after the entry of the last DTMF tone. This timer is programmable between 0.1
and 9.9 seconds. When initialize, this timer will default to 1 second.
Repeater ID Timer [*607*]
This timer sets the time between transmissions of the repeater ID. The ID
occurs when a repeater user stops transmitting. This timer is programmable
between 1.0 and 1799 seconds. When initialize, the timer defaults to 480
seconds.
Squelch Tail Message Timer [*608*]
This timer sets the time between transmissions of the squelch tail message.
The message occurs when a repeater user stops transmitting. This timer is
programmable between 1.0 and 1799 seconds. When initialize, the timer defaults
to 1799 seconds.
Drop Out Message Timer [*609*]
This timer sets the time between transmissions of the drop out message. The
message occurs when a repeater stops transmitting. This timer is programmable
between 1.0 and 1799 seconds. When initialize, the timer defaults to 1799
seconds.
Voice Delay Timer [*610*]
The CAT-300 generates a PTT output and after a short delay the voice speaks.
This delay is field programmable. This feature is useful in repeater systems
using CTCSS tone squelch or multiple linking where the system is slow to come
up. The voice delay timer can be programmed between 0.1 and 9.9 seconds. When
initialize, the timer defaults to 1.0 seconds.
5-11