Manual Evo 8.0 - PhotoBooth Digital Centre

· SOUND PROBLEMS
Problem
The sound does not work
Causes
The volume is not correct.
The configuration menu has the sound set to OFF.
Solutions
Adjust the volume with the control placed below the test,
free-play and start buttons.
Change the sound configuration from the test menu
(black button).
· PRINTER PROBLEMS
Problem
The printer does not print any
photos
Causes
The printer is disconnected.
The printer is out of ink or paper.
The paper or the ink sheet was not
properly installed.
Incorrect paper.
USB/ LPT Atmel chip position is
incorrect.
Solutions
Switch on the printer.
Call the person in charge
Correctly place the paper
and the ink.
Use only CK9550-DC type paper.
· PC PROBLEMS
Problem
Install a brand new Control Board
with Atmel chip and jumpers.
Causes
This problem is due to a hardware
malfunction.
Check the green Capture Board, as
it is probably out or half way in.
Problem
The printer does not switch on
Causes
The printer is disconnected.
The printer does not receive electric
supply.
Solutions
Connect the printer.
Be sure that the cable is correctly
connected.
Problem
It prints one or more white lines
Causes
Thermal head is broken.
Solutions
Replace thermal head.
Solutions
Turn OFF the PC.
Take out the Capture Board. And put
it again (all the way in).
Screw in tightly and check again that
it is all the way in, and did not move
little out during screwing.
Turn ON the PB and check it.
73